Recommended Nuts and Bolts to Install the PackEm Rack for Utility Trailers # PK-6-OP1
Updated 03/19/2013 | Published 03/15/2013 >
Question:
The rack comes without bolts what size bolts are needed to fasten these is it 3/8?
asked by: Mike
1
Helpful Expert Reply:
I checked with our contact at Packem and he informed me that they usually recommend using 5/16 x 1-1/2 bolts that are grade 5 or 8 with flat washers and matching lock nuts to instal the Pack Em Rack for Utility Trailer # PK-6-OP1.
expert reply by:
Jameson C
1
Product Page this Question was Asked From
Pack'Em Rack for Open Utility Trailers - Holds 3 Trimmers, 1 Blower, 1 Line Spool, 1 Cooler
- Trimmer Racks
- Utility Trailer
- 1 Backpack Blower
- 1 Cooler
- 1 Line Spool
- 3 Trimmers
- Pre-Drilled Holes
- Locks Included
- PackEm
more information >
Continue Researching
- Q&A: Replacing Trailer Buddy 32220 Reverse Solenoid on Ranger Boat Trailer
- Q&A: Replacing TDE 70LP On Swing Away Tongue
- Q&A: Troubleshooting A Demco Hijacker Autoslide 5th Wheel Hitch That Won't Slide
- Q&A: What Trailer Widths Does 23x79 Rack'Em Heavy-Duty Cargo Basket for Open Trailers # RA-14 Fit
- Q&A: Could RackEm Heavy-Duty Cargo Basket for Open Trailers Fit Trailer that is 83 inches Wide
- Q&A: How Much Does The etrailer Hitch e58ZV For A 2025 Kia Niro Weigh?
- Q&A: Will Blower Rack for Utility Trailers Be Compatible with 12 Inch High Mesh Sides
- Article: How to Measure a Trailer Axle
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: How to Install E-Track in 3 Easy Steps
- Article: How to Measure for Trailer Hitch Drop
- Article: Installing an Electric Brake Controller on 2007-2013 GM Full-Size Truck or 2007-Present GM SUV
- Article: How to Correct Noise from Exhaust Rattling Against a Trailer Hitch
- Article: Trailer Wiring Diagrams

