Installation of the Block Adjustment Washers on Reese Weight Distribution System # RP67509

Updated 01/11/2013 | Published 01/09/2013

Question:

How do I know where to set the block washer

asked by: Jeff P

Expert Reply:

In the Reese Weight Distribution System, part # RP67509, the block style washers are used to adjust the tilt of the weight distribution head. This uniquely shaped washer can be rotated and positioned between blocks on the weight-distribution head for simple, secure positioning. And the numbered sides provide reference points should you need to adjust your system between different tow vehicles.

In the initial installation of the ball mount to the weight distribution shank you will install a bolt and a regular washer at the bottom of the ball mount and then rotate the ball mount up until the hitch ball is at the correct height of your trailer coupler. Then, install the bolt with the block style adjustment washers on the top of the ball mount and the adjustment washer needs to be set at the position that will get the hitch ball at its correct height. This will give you a starting point to set up your weight distribution system. After further measuring you may need to adjust the washers to change the tilt or height of your hitch ball.

I am including a link to the installation instructions on the # RP67509 system and a link to a video of a weight distribution system that has the block style adjustment washers being installed on a vehicle. It will show you how to initially install the washers and how to adjust them if it is needed.

expert reply by: Jeff D