Installation of the Curt Class III Trailer Hitch # C13128 on a 2012 Range Rover Evoque Dynamic

Published 12/27/2012

Products Featured in This Question

Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"

(46)

$201.35

Curt Cam Buckle Stabilizing Strap for Hitch-Mounted Accessories - 61" x 1" - Qty 1

(667)

$15.80

1-7/8" Hitch Ball - 1" Diameter x 2-1/8" Long Shank - Chrome - 2,000 lbs

(2634)

$11.68

Curt Ball Mount for 2" Hitches - 3/4" Rise, 2" Drop - 10-1/4" Long - 7,500 lbs

(3881)

$32.61

Question:

Hello I saw your response to one of your customers from this web site: http://www.etrailer.com/question-47900.html I saw a picture of an Evoque and it was for a round exhaust. How about for the square exhaust such as the Evoque Dynamic? Thanks

asked by: Alvin

Expert Reply:

I spoke with my contact at Curt and he assured me that the installation of the Curt Class III Trailer Hitch, # C13128, is the same on your 2012 Range Rover Evoque Dynamic as it is on the Pure and Prestige trim packages. Your square exhaust tips will have no affect on the installation.

There will be some minor trimming of the heat shield and fascia required for installation and the exhaust will need to be temporarily lowered. I have attached a link to the installation instructions for you to check out.

If you will be using this hitch to carry hitch mounted accessories such as a bike rack or cargo carrier, then I also recommend picking up the Curt Stabilization Strap, # 18050. Curt requires all non-trailer loads to be supported by a stabilizing strap.

You will also want to pick up a ball mount, # D-4, Hitch Pin and Clip, # PC3, and a hitch ball, # 19260 for 1-7/8 inch ball or # 19247 for a 2 inch ball.