How to Wire 95 Amp Deka Battery Isolator for Installation on 1986 Toyota 4Runner
Updated 11/19/2020 | Published 11/18/2020 >
Products Featured in This Question
Question:
Hi folks, Interested in Deka 95-amp Battery Isolator DW08770. I would like to confirm how it should be wired to my 1986 Toyota 4 Runner. Alternator connector has L yellow fault wire, S white, Sense? and IG red, only on when IGN switch on. Alternator stud has the thick white B wire that goes to the battery. Based on Jamesons post https://www.etrailer.com/question-371433.html: Keep OEM wires on connector unchanged. Tap Terminal E through a ckt Brkr to IG wire. Move Alternator output to Pin A of isolator. Connect Starter batt to terminal 1 of isolator.
asked by: Raymond D
0
Product Page this Question was Asked From
Deka Battery Isolator - 95 Amp
- Battery Charger
- Battery Isolators
- 12V
- 24V
- 36V
- 48V
- 50V
- 6V
- Maintains Only
- Vehicle Battery to Auxiliary Battery
- Deka
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Does Speed Affect Tire Wear on a Trailer Tire
- Q&A: Potential Causes for Uneven Wear on Trailer Tires
- Q&A: RV Trailer Battery Charging With 2019 Ford F-350
- Q&A: Replacement Brake Calipers For Dexter 89-2 Calipers
- Q&A: Replacement Propane Gas Detector For CCI Controls 7719
- Q&A: Door Hinge for 2001 Exiss Horse Trailer
- Q&A: How To Determine the Correct Boat Trailer Jack Weight Capacity
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Charge a Trailer Battery While Driving: 3 Common Problems (And How to Fix Them)
- Article: How Your RV Water System Works: A Complete Newbie's Guide
- Article: Trailer Wiring Diagrams



