Mounting Hole Dimensions for JR Products Door Catch 37270505
Updated 11/20/2020 | Published 10/21/2020 >
Question:
I’d like to replace catches with these but cannot find screw spacing. I originally used AP Products 013-019 and hope to use same holes all drilled in fiberglass. What is the screw spacing on the JR Products # 37270505?
asked by: Dennis
0
Expert Reply:
I had our warehouse measure the JR Products RV Cabinet Catch and Strikes # 37270505 you mentioned. The mounting holes on the latrger catch are 1" apart center to center, and the smaller brackets measure 1-1/8" center to center as shown in the included diagram.
I included a video of the # 37270505 for you to take a look at.
expert reply by:
Samuel C
0
Product Page this Question was Asked From
Featured Help Information
Miscellaneous Media
Continue Researching
- Shop: RV Cabinet Catch and Strikes
- Q&A: Will the Timken Bearing Kit TMK52VR Work w/a Dexter 3,500 lbs Axle?
- Q&A: RV Bathroom Faucet Recommendation with Swivel Feature and 1.2 GPM Flow
- Article: Trailer Wiring Diagrams
- Article: Stability Control for Heavy Duty Vehicles
- Q&A: Flat Tow Setup For A 2024 Ford Bronco Raptor
- Q&A: Recommended Suspension Improvement for a Jeep Wrangler When Towing a Trailer
- Q&A: Replacement RV Fridge to Replace Dometic RM2193
- Q&A: Wiring Diagram for 7-Way Round Pin Trailer and Vehicle Side Connectors
- Q&A: Are Dexter Bearing Kits as Good as Timbren Bearing Kits for Trailer Axle
- Article: 5 Things to Know About Weight Distribution Hitches



