How Big of a Hole is Required to Drill to Install the RodBuckle Fishing Rod Tie-Down Strap
Updated 11/19/2012 | Published 11/17/2012
Question:
What is the hole dimension to be cut into the boat for this part ?
asked by: David R
0
Expert Reply:
To install the RodBuckle Retractable Fishing Rod Tie-Down Strap # IMF14200-02 that you referenced you will need to cut a rectangular hole that is 1-15/16 inches long by 3/8 inches tall and then drill two 1/8 inch holes on either side of the rectangular hole.
The # IMF14200-02 instructions come with a template to make the hole cutting as easy as possible. I attached a copy of these instructions for you to check out.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
RodBuckle Retractable Fishing Rod Tie-Down Strap with Concealed Mounting Kit - 2" x 24"
- Fishing Rod Holders
- Rod Tie-Downs
- Deck
- Gunwale
- Bolt-On
- Black
- BoatBuckle
more information >
Continue Researching
- Q&A: What Is The Smallest Available Spindle Nut For 2.5k Axle?
- Q&A: Offset On Kenda Karrier KR35 ST175/80R13 w/ 13" Aluminum AM03 Wheel
- Q&A: Should Reverse Lockout Solenoid of Actuator Make Clicking Sound
- Q&A: 4 Bolt Hub and Spindle Nut for a CE Smith 2k Trailer Axle
- Q&A: What Do 13 inch Trailer Wheels Have for Offset
- Q&A: Do All Trailer Wheels Have a Zero Offset?
- Q&A: Availability Of Trailer Hub With .75" Outer And 1.25" Inner Bearings
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Wiring Trailer Lights with a 5-Way Plug (It's Easier Than You Think)