Parts Needed to Use Yakima SkyLine Tower Setup from ARE Truck Camper on 1998 Jeep Wrangler
Published 05/22/2020
Products Featured in This Question
Question:
Jon did a great job. But, it might just be easier, and cheaper, to use 4 Landing Pad 6 on the Jeep top since the Jeep top is fairly small and will usually, if not always, be used with a cargo basket. In this instance I would use 4 Landing Pad 6 - right?
asked by: William B
Helpful Expert Reply:
To use your Yakima SkyLine setup on your 1998 Jeep Wrangler you just need the 42" Tracks # Y01126 and 2 sets of the Landing Pad 1 # Y00221.
This will then allow you to easily transfer the SkyLine Towers # Y53TR and whatever crossbars you are currently using, like the 50" JetStream # Y00425. Just be sure that the crossbars from your ARE camper shell don't stick out further than the side mirrors on your Jeep.
I have attached installation instructions for you to check out.
Product Page this Question was Asked From
Featured Help Information
Instructions
Continue Researching
- Q&A: Will the Surco Safari 5.0 Rooftop Cargo Rack 84" x 50" Fit on the Roof of a 2005 Ford Excursion?
- Q&A: Can the Yakima Tracks for Roof Racks Be Trimmed
- Q&A: Can Yakima 54" HD Tracks be Cut down for Smaller Area on Shell/Topper
- Q&A: Can Thule Roof Rack Install in Yakima Roof Rack Tracks
- Q&A: Difference Between Yakima Standard and HD Tracks
- Q&A: Yakima Round Bar Roof Rack Components to Fit 2017 Chevy Silverado 4 dr Crew Cab
- Q&A: Best Truck Bed Mat For a 2022 Honda Ridgeline
- Article: Roof Rack Information
- Article: How to Strap a Bike To a Roof Rack
William M.
5/22/2020
Jon did a great job. But, it might just be easier, and cheaper, to use 4 Landing Pad 6 on the Jeep top since the Jeep top is fairly small and will usually, if not always, be used with a cargo basket. In this instance I would use 4 Landing Pad 6 - right?