Does the Curt Hitch part # C13194 include the Fish Wires to Install it
Updated 05/20/2020 | Published 05/18/2020
Question:
Are the 7/16inch fish wires described in the directions included or do I need to purchase them separately?
asked by: Bob
0
Expert Reply:
The Curt Trailer Hitch Receiver part # C13194 comes with all of the hardware you will need for installation including the fish wires you mentioned. I have linked an installation video for you to check out that will show you the step by step process including the use of the fish wires. Check it out.
expert reply by:
Randy B
0
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- For Towing
- Class III
- 525 lbs TW
- 3500 lbs GTW
- 5000 lbs WD GTW
- 2 Inch Hitch
- 525 lbs WD TW
- Concealed Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Will Installation of Oris Hitch on 2019 Volvo XC90 T6 Require Trimming/Interfere With Kick Sensor
- Q&A: Is Curt RVi Series Shadow 2 Compatible With 2025 Jeep Gladiator
- Q&A: Can a 4-Way Trailer Connector be Plugged Into a 5-Way Vehicle End Trailer Connector
- Q&A: Does the Oris AK41 Hitch Block the Foot Sensor on a 2021 Volvo XC90?
- Q&A: 10k Dexter Replacement Hub for a 8-415
- Q&A: Standard And traditional Wiring Configurations For 7-Way Trailer Connectors
- Q&A: Where is the Brake Switch Wire on a 2014 GMC Savana Van to Install a Brake Controller
- Article: Which Hitches are Made in the USA
- Article: Routing the Power Wire for a Trailer Wiring Harness