Adapter to Connect 1/4 inch Brake Line to Hydrastar Electric Over Hydraulic Brake Actuator

Updated 04/16/2020 | Published 04/15/2020

Products Featured in This Question

Brake Line Fitting for Hydrastar Hydraulic Brake Actuators - 1/4"

(6)

$31.81

Hydrastar Electric Over Hydraulic Actuator for Disc Brakes - 1,600 psi

(242)

$945.94

Question:

I am trying to make the final connections in my new brake system on my tri-axle boat trailer. I have the Hydrastar HBA16 electric over hydraulic actuator, and Kodiak disc brake kit K2HR526DS x2 all purchased on etrailer. I am using 1/4inch stainless steel brake line to make the runs from the actuator to the brakes. Can you tell me what the thread count/pitch on this part #HS43-9035 is. I believe I need this to make the connection to the Hydrastar however I am still trying to track down these additional fittings: 1 male flare fitting to connect 1/4inch brake line to HS43-9035, 3 1/4inch tee connections, one for T off at front of trailer to run a stainless line down each I-beam not necessary but how I want it done, two for T off at each front axle with a brake hose connecting to each front caliper brake hose also needed. Then I need two additional 1/4inch connections for the stainless lines and two additional brake hoses to make the connection at the second axle brake calipers. Are you able to help with these ions? Thank you,

asked by: Thomas M

Expert Reply:

The adapter part # HS43-9035 that you referenced is an adapter that plugs into the back of the HydraStar Actuators like the part # HBA16 that you have to go from 3/16 inch line size to 1/4 inch like you have now.

We don't have the 1/4 inch tee fittings you are looking for oddly enough.

expert reply by: Jameson C