Replacement Cab Clamp for an Extang Trifecta 2.0 Soft Tonneau Cover
Published 04/08/2020
Question:
Does this latch fit the Trifecta 2.0? The latch we currently have has a five on the side. I think that might be the size.
asked by: Cari
0
Expert Reply:
Yes, the Replacement Cab Clamp Assembly part # EX1034 is a fit for a Extang Trifecta 2.0 Soft Tonneau Cover. In regards to installation, you'll need to disconnect the screws from the crossbow of the cover so that it will drop down and the cab clamp assembly will then be able to slide out of the rail.
expert reply by:
Conner L
0
Product Page this Question was Asked From
Replacement Cab Clamp Assembly for Extang Trifecta Tonneau Covers - Qty 1
- Accessories and Parts
- Tonneau Cover
- Clamps
- Extang Trifecta
- Extang
more information >
Continue Researching
- Q&A: How Does Replacement Clamp for Extang Trifecta EX1034 Install
- Q&A: How to Replace the Rear Tailgate Clamp on an Extang Trifecta 2.0 Tonneau Cover
- Q&A: How To Tell If Parts Are Missing From Rear Panel Extang Solid Fold Tonneau Cover That Blew Off Truck
- Q&A: Replacing Clamps on Extang Solid Fold Tonneau Cover
- Q&A: Removing Damaged Cab Clamp From Extang Trifecta Tonneau Cover
- Q&A: Replacement Clamps for Extang Solid Fold 2.0
- Q&A: Troubleshooting Extang Trifecta Clamp that is Stuck After Unscrewing
- Article: Snow Tire Chain Overview: How to Buy the Right Tire Chains
- Article: Performance Chips and Modules