How to Remove Bearing Buddy Trailer Bearing Protectors
Updated 07/11/2012 | Published 07/09/2012 >
Question:
Please furnish instructions for removal of Buddy Beadrings. I have a bad front bearing and must remove the Buddy in order to get to the hex nut.
asked by: Marshall R
0
Expert Reply:
Bearing Buddies like # BB2441 fit very tight into a trailer hub. In order to get them out, you will need to use a rubber mallet and persuade them out. Once the Bearing Buddy starts to unseat from the hub you can grab it and wiggle it out.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Bearing Buddy Bearing Protectors - Model 2441 - Chrome Plated - Qty 2
- Trailer Bearings Races Seals Caps
- Caps
- Bearing Protector Grease Cap
- 2.44 Inch
- 4400 lbs Axle
- 5200 lbs Axle
- 6000 lbs Axle
- 7000 lbs Axle
- Bearing Buddy
more information >
Continue Researching
- Q&A: Replacement DB35 Disc Brake Assembly
- Q&A: What Inner and Outer Bearings Does 3,500 lb Axle Disc Brake Kit Use
- Q&A: Option For Replacing Tie Down 46304 Cailpers
- Q&A: SmartPlug RV TV/Internet Inlet Dimensions
- Q&A: Bearing Buddies Needed for Al-KO 7200 lb Hubs
- Q&A: Replacement Brake Calipers for Dexter 10" Brakes
- Q&A: Difference Between Furrion Chill Cube FR24TQ, FR59TQ and FR67TQ
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Article: Hitch Anti-Rattle Devices: The Ultimate Guide
- Article: Most Popular Wheel Bearings
- Article: How to Bleed Your Trailer Surge Brakes
- Article: 5 Products You Need For Your Next Camping Trip (2022)
- Article: What are the Common Types of Propane Fittings Used on RVs?

