Trailer Wiring Connector # 118303 for 2005 Chrysler Pacifica Shows Constant Power on Running Lights
Updated 06/13/2012 | Published 06/10/2012
Question:
Have a trailer wire harness #C55530 and a cr-600led step. With all Lights OFF, theres a faint light on the LEDs of Cr-600led all of the time. When checking with volt meter at trailer plug PK11410 theres always power to the running lights terminal. I know that the LEDs or not enought to drain the car battery put is this normal.
asked by: Michael S
Expert Reply:
There should not be any major constant power draw on any of the circuits on wiring harness # C55530. Though there may be some residual power coming through. There may be a short or ground issue that is causing some power to trickle through. Check the vehicle side connector for any dirt or corrosion and clean it out. Do the same for the connector on # CR-600LED.
Product Page this Question was Asked From
Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Vehicle End Connector
- Powered Converter
- No Tow Package
- 4 Flat
- Plug and Lead
- Plug-In
- Hidden
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Is There a Cover for a Single 30 Lb Propane Tank
- Q&A: Replacement Gas Strut For a Stabilus 654150 0550N 275/12 A 15
- Article: Demco Vehicle-Specific Base Plates
- Q&A: Trails West Horse Trailer with Dome and Spot Lights That are Not Functioning
- Q&A: How to Manually Operate Bulldog Powered-Drive Jack Kit BD1824180100 When No Power is Available
- Q&A: What Inverter Would Work as a Replacement to the WIN-12/300TL?
- Q&A: Are There Fold-Down RV Steps For A 21" Entyr Height Measurement
- Q&A: Replacement Lens for Bargman 59 Series Trailer Taillight
- Article: How to Mount a Truck Bed Camper