Red LED on Energize III Brake Controller # 81741B Lit When Brake Applied and No Trailer Connected
Updated 05/23/2012 | Published 05/21/2012
Question:
Withouth the camper attached in any way at all, the red indicator light still comes on everytime the brakes are applied. Should this be happening with this controller?
asked by: Dan H
0
Expert Reply:
I went out to our warehouse and pulled one of the Energize III controllers off of the shelf and bench tested it.
I found that with no trailer connected, the red light on the controller will indeed light up when the vehicle brakes are applied. Your controller is not malfunctioning and is good to go.
expert reply by:
Mike L
0
Product Page this Question was Asked From
Custom Wiring Adapter for Hayes Brake Controllers - Dual Plug
- Accessories and Parts
- Trailer Brake Controller
- Wiring Adapter
- Plugs into Brake Controller
- Vehicle Specific
- Hayes
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Electric Brake Controller Installation on Dodge Ram Trucks to 2012
- Q&A: Troubleshooting S.H and P.L Codes on Tekonsha Prodigy P2 Brake Controller
- Q&A: Brake Controller Connector Location in 1997 Dodge Ram
- Q&A: Brake Controller Connector Location on 2005 Dodge Ram 1500
- Q&A: Replacement Option for High Pointe RV Microwave EM925RSL
- Q&A: Replacement AC Unit for a Dometic 15,000 Btu AC Unit
- Q&A: Recommended Replacement for Atwood GC10A-4E RV Water Heater
- Article: How to Install a Brake Controller on Chevrolet / GMC 1999-2006 Pickups