How To Replace Nozzle On The Lippert Waste Master Hose Kit
Published 11/27/2019 >
Products Featured in This Question
Question:
How do you connect the nozzle to the hose?
asked by: Larry
Helpful Expert Reply:
The Replacement Nozzle for Waste Master RV Sewer Hose with Seal Kit part # LC349521 is the replacement nozzle for the Lippert Waste Master RV Sewer hose kit part # LC359724.
To replace the original nozzle with the Replacement Nozzle and connect it to the hose you will need to drive the two dowel pins out near the clear part of the nozzle. Once you have the dowel pins driven out you can swivel the nozzle until it comes off of the hose. The replacement nozzle kit LC349521 comes with the replacement dowel pins, seal and compound to replace the nozzle. You'll need 1/8" punch and a hammer to replace the dowel pins to reconnect the nozzle. The replacement nozzle does come with specific instructions on this.
Continue Researching
- Q&A: Which Slide Topper For 154 Inch End to End Slide-Out on 2020 Coachmen Apex Ultra-Lite
- Q&A: Can I Use The Active Controls AS97FR On A 20 Amp House Circuit That Is Tripping?
- Q&A: Will the Lippert Solid Step RV Steps Work With an Airstream Trailer?
- Q&A: Parts Needed To Connect A Macerator Hose To A Dump Station Waste Drain
- Q&A: Replacement Camera For A Voyager WVSO511 RV Camera System
- Q&A: Is There A Backup Camera Available That Is Compatible With Voyager Monitor WVOS541
- Article: The Ultimate RV Camping Checklist for Your First Year RVing
- Article: Cleaning Your RV Black Water Tank in 4 Easy Steps
- Q&A: Correct Replacement for Parallax 8355 Converter