Will the JR Products RV Floor Registers Fit a 4 Inch x 9-3/4 Inch Cutout

Updated 11/18/2019 | Published 11/17/2019

Products Featured in This Question

RV Floor Vent - 4" x 10" - Steel - Brown

(149)

$12.94

RV Floor Vent - 4" x 8" - Steel - Brown

(149)

$13.04

Question:

I have 2019 Cedar Creek with 5 floor heater vents undamped brown but are plastic and I would like to replace with metal. All the sites Ive looked at the opening size is 4inch x 10inch - the openings in the floor in this RV are 4inch x 9-3/4. and the plastic that goes in the opening is the same. Do you have anything that will fit? Thanks.

asked by: Eric P

Helpful Expert Reply:

The JR Products Undampered RV Floor Register part # 37202-28995 should fit just fine though you might need to shave a bit off each side of the opening. That said, the required cutout is actually slightly smaller than 10" and I am pretty sure this is the size you need. The next smallest size down is the JR Products Undampered RV Floor Register part # 37202-28955 which is 4" x 8".

expert reply by: Conner L