Will Hydrostar Brake Actuator Caps Fit On Dexter Brake Actuators
Updated 10/22/2019 | Published 10/21/2019
Question:
Hello, I have a couple questions. What is the size of this cap? It appears similar to the reservoir caps on the Dexter brake actuators which is what I have, will this fit the reservoir?
asked by: Eric B
Expert Reply:
I was able to contact Hydrastar for the following dimensions to help you compare. The Replacement Filler Cap for HBA-Series Hydrastar Actuators # HBA-BC uses 3 locking tabs. The tabs themselves are 1/4" and are 1" apart, located in a direct line across from each other. The inner diameter of the cap wall to wall is 1-1/2".
While I did reach out to Dexter they weren't able to provide their cap dimensions so I can't confirm this cap will fit Dexter actuators.
Included is the review video for this cap for additional information.
Product Page this Question was Asked From
Replacement Filler Cap for HBA-Series Hydrastar Actuators
- Accessories and Parts
- Brake Actuator
- Disc Brakes
- Hydraulic Drum Brakes
- Master Cylinder
- Cap
- Hydrastar
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: 2023 Volkswagen Jetta Trailer Wiring Harness Recommendation for Small Utility Trailer
- Q&A: Trailer Wiring Recommendation for a 2025 Mazda CX-70
- Q&A: How To Install A Brake Controller On 2019 Chevy Equinox With Factory Package
- Q&A: What is the Best Grease for Trailer Bearings
- Q&A: Replacement Water Heater Element for Atwood EHM 6SM
- Q&A: Replacement Bearings and Brake Assemblies For 1998 Dexter 9000lb Axle
- Q&A: Towing a 2013 Kia Sorento AWD Behind Motorhome
- Article: How to Accurately Measure Trailer Leaf Springs