bing tracking image
Q & A Icon

No Trailer Tail Lights On 2016 Lexus NX 200t With Curt T-Connector Vehicle Wiring Harness  

Updated 10/15/2019 | Published 10/14/2019

Question:

I purchased a CURT wiring assembly from etrailer and hooked it all up. The blinkers and brake lights work, but the tail lights do not work on the trailer. I bought 4-pole flat connector tester and it also showed the tail lights not working.

0

Expert Reply:

The correct Curt T-Connector Vehicle Wiring Harness for a 2016 Lexus NX 200t (F-Sport Included) is part # C56268 so we first need to confirm this is what you have. Once this is done we then need to confirm the vehicle's running lights are working correctly. If so then test the brown wire with a circuit tester before it enters the converter box while the signal is active. If you don't have power here then there is an issue with the vehicle's wiring so make sure you have the pigtail ran to the correct sides and that none of the pins inside the pigtails are damaged. If you do have power here then test the brown wire on the other side of the converter box while the signal is active. If you don't get power here then we know you either have a bad ground or the converter box is faulty and needs to be replaced.

expert reply by:
0
Conner L

Product Page this Question was Asked From