Where is the Rise Measured from on a Curt Euro Ball Mount
Published 03/30/2012
Question:
For the Curt Euro Ball it says •Rise: 3-1/8inch from top of inside of hitch opening Question: is it 3-1/8inch to the bottom or top of the ball? Thanks!
asked by: Zaur G
0
Expert Reply:
The 3-1/8 inches of rise that the Curt Class II Euro Style Drawbar # C45562 has is measured from the top of the shank to the beginning of the vertical bend below the ball.
Check out the video I attached to see this measurement.
expert reply by:
Jameson C
0
Continue Researching
- Q&A: Trailer Wiring Harness Recommendation for a 2014 Ford Focus ST Hatchback
- Q&A: Recommended Torque for Tightening Curt Hitch Balls to Ball Mount
- Q&A: Weight of Curt Trailer Hitch C11567 For 2020 Toyota C-HR
- Q&A: Parts Needed to Tow Small Trailer with Motorcycle with 2018 Toyota C-HR
- Q&A: Looking For Lift Kit For A 2006 Single Axle Trailer With Dexter Torsion Axle
- Q&A: Recommended Euro-Style Ball Mount for a 2015 Nissan Altima with Curt Class I Trailer Hitch
- Q&A: What is the Difference Between Class 1 and Class 2 Hitches for the Scion XB
- Article: How to Measure for Trailer Hitch Drop
- Article: Rooftop Cargo Carriers
- Article: Determining Trailer Tongue Weight
- Article: What Exactly is Tongue Weight?
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Performance Chips and Modules