Using B Pillar on 2017 Honda Ridgeline Touring to Install Pop & Lock Custom Tailgate Lock # PAL8600
Updated 09/12/2019 | Published 09/11/2019
Question:
I have a 2017 Honda Ridgleline Touring. I was wondering if you have detailed instructions on how to install the PAL8600 at the B pillar.
asked by: Todd S
Expert Reply:
There aren't any official installation instructions for routing the wiring from the Pop & Lock Custom Tailgate Lock # PAL8600 to the B pillar on your 2017 Honda Ridgeline Touring but the manufacturer did provide us with a couple images and general steps that can be used.
You basically just need to route the wiring to the B pillar, which is located by the driver's side seatbelt in your Ridgeline. Once there find the small red and yellow wires (lock and unlock) that you will connect to the Pop & Lock wiring. The mentioned images have been attached along with an install video on the 2019 Ridgeline. You can follow along with the video but then simply route the wiring to the B pillar instead of the engine compartment as shown.
Product Page this Question was Asked From
Pop & Lock Custom Tailgate Lock - Power - Black
- Tailgate Locks
- Lock Only
- Power Lock
- Keyed Unique
- Vehicle Specific
- Black
- Pop and Lock
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Do the Pop and Lock Tailgate Handles for a 2010 Honda Ridgeline Lock Both Handles
- Q&A: Replacement Prop Rod Assembly for Leer HF650M Tonneau Covers on a 2022 Toyota Tacoma
- Q&A: Replacement Parts for a HF650M Leer Tonneau Cover LE94FR That Fits a 2019 Ford F-150 w/ a 5-1/2' Bed
- Q&A: How to Wire Pop & Lock Tailgate on Honda Ridgeline Using Wiring Behind B-Pillar
- Q&A: Installing The BakFlip F1 Hard Tonneau Cover On 2012 Honda Ridgeline
- Q&A: Will the BAKFlip G2 Hard Tonneau Cover # BAK26601 Limit Trunk Access on a 2014 Honda Ridgeline
- Q&A: Does The BAKBox 2 and BAKFlip Cover Allow Access To Trunk In Honda Ridgeline