Wiring to Install Tekonsha Prodigy P2 Brake Controller on a 2013 Cadillac Escalade

Updated 08/08/2019 | Published 08/07/2019

Question:

I have a prodigy p2 trailer brake controller. I have the wire that plugs into the factory spot on my 2006 gm. Was curious what model number I need to plug into my Escalade and where exactly under the dash it is. I see 2 open spots

asked by: Sam

Expert Reply:

You actually need to connect some wiring to install the Tekonsha Prodigy P2 # 90885 on your 2013 Cadillac Escalade as there are no plug-in connectors.

There is some wiring though which is located near the data link connector so you'll need to connect them to the following wires on the P2:

Dark Blue - Blue (P2)
Red/Black - Black (P2)
Light Blue/White - Red (P2)
White - White

If you don't still have the pigtail that came with the P2 then you can use part # 7894 which comes with butt connectors and gives you a way to easily disconnect the brake controller without cutting wires.

expert reply by: Jon G