What Is the Max Length Of Wire Between Battery and Inverter With Go Power 1,000 Watt Pure Sine
Updated 08/05/2019 | Published 08/04/2019
Question:
How many ft of no 8 wire can I run from two 6 volt batteries each has 235 amp hours each to the inverter with the fuse installed in line .They are wired in series . Thanks
asked by: Greg G
Helpful Expert Reply:
The Go Power Industrial Pure Sine Wave Inverter part # 34279948 actually calls for a minimum of #4 AWG so I cannot recommend you use #8 AWG. The combined cable length between the batteries and inverter should be no more than 10' long in order to achieve maximum efficiency and to reduce fire hazards.
Product Page this Question was Asked From
Go Power Industrial Pure Sine Wave Inverter - GFCI - 1,000 Watt - 12V
- Power Inverter
- Pure Sine Wave
- Kitchen Appliances
- 12V
- 1000 Watts
- Inverter Only
- AGM/Gel/Lead Acid
- Lithium
- Outlet
- RV
- Go Power
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Difference Between Valterra T1003VP and T1003VPM Waste Valves
- Q&A: Is Progressive Dynamics 2000 Watt Inverter A Good Replacement For WF-5110R 1000W Inverter?
- Q&A: Inverter Replacement Recommendation for WFCO WF5110RS
- Q&A: How To Install The Progressive Dynamics Pure Sine Wave Inverter With Transfer Switch
- Q&A: Using Battery Converter/Charger With Progressive Dynamics Pure Sine Wave Inverter Transfer Switch
- Q&A: Recommended 50 Amp Transfer Switch To Accommodate Shore Power, Generator Power, And Inverter Power
- Q&A: What are the Power Ratings of the Go Power! 1500 Watt and 2000 Watt Inverters When in Standby Mode
- Article: The Best 5th Wheel Hitches
- Article: Choosing the Right Suspension Kit for Your Truck and Trailer
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: How to Repair an RV Roof
- Article: How Much Solar Power Do I Need For My RV?
- Article: 4-Step Guide to Installing RV Solar Power