Mounting Hole Distance Of Optronics LED RV Dome Light UCL60CSWNB
Updated 07/27/2019 | Published 07/19/2019
Question:
What is the measurement between the mounting holes center on center for this light. I am trying to replace a 3inch round light with a switch on my RV with holes 2 3/4inch apart. I think this light will work if the mounting holes are the same. Thank you.
asked by: David
Helpful Expert Reply:
I went down to the warehouse and measured Optronics LED RV Dome Light w/ Trim Ring - Click On part # UCL60CSWNB and the mounting holes measure 2-1/4" a part center on center.
Please let me know if you don't think you can make this work and I will be happy to measure another light for you.
Product Page this Question was Asked From
Optronics 12V LED RV Dome Light - Single - 3" Diameter - Black Trim
- RV Interior Lights
- Dome Light
- Warm White
- Touch Sensor
- Surface Mount
- LED Light
- 12V
- Nickel
- Optronics
more information >
Continue Researching
- Shop: Optronics 12V LED RV Dome Light - Single - 3" Diameter - Black Trim
- Q&A: Recommended Replacement For Dome Light # L26-0091-NW-REV
- Q&A: How To Tell If 2024 Jeep Grand Cherokee Overland L Has Active Air Shutters
- Q&A: Switch Recommendation for Dual LED Boat Spreader Light
- Q&A: What Brake Controller For 2020 Chevy Colorado & Is There Plug-In Harness
- Q&A: Fuse For Progressive Dynamics 9200 Inteli-Power Converter
- Q&A: How to Fit Inno Wedge 660 on 2020 Toyota 4Runner with Factory Roof Rack
- Q&A: Replacement Kwikee Step Motor for a Part 300-1457
- Article: Can You Flat Tow a 2024 Jeep Grand Cherokee?
- Article: Best Vehicles to Flat Tow Behind an RV