What Might Cause Trailer Battery to Die When Connected to Tow Vehicle
Updated 07/16/2019 | Published 07/15/2019
Products Featured in This Question
Question:
My trailer battery goes dead when I hook up and travel with it ,Ive check all connection and they are wired right ,battery also checks out
asked by: George W
Expert Reply:
What all is connected to your trailer battery? You'll need to go through the list of all connections made to your trailer's battery so that you can determine what all could be drawing amperage and then make sure all of those accessories are turned off when you are towing.
The 12 volt accessory pin of your 7-way can put a maintenance charge on your battery as well if needed. This is the pin in the 1:00 position on the vehicle 7-way. You'd want to run 10 gauge wire like part # 10-1-1 (sold by foot) to the positive battery post to do this.
Product Page this Question was Asked From
Hopkins Pull to Test Breakaway Switch with 48" Long Cable
- Accessories and Parts
- Trailer Breakaway Kit
- Switches
- Hopkins
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Parts Needed to Flat Tow 2018 Ford F-150 With 4 Wheels Down
- Q&A: Parts Needed to Flat Tow 2019 Ford F-150
- Q&A: Recommendation for Trailer Brakes On a 16 Foot Enclosed Trailer with 2 Axles And 5,000 LB GVW
- Q&A: Replacement Propane Gas Detector for an Atwood 31013 Propane Detector
- Q&A: Delay in Electric Over Hydraulic Trailer Brakes with Dexter System
- Q&A: How to Initially Adjust the Dexter Nev-R-Adjust Electric Trailer Brakes
- Q&A: Replacement 12 Inch Brake Assemblies for Redline EB01-140 and EB01-145 From Dexter Axle
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: How to Measure a Trailer Axle
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Testing Trailer Brake Magnets for Proper Function