What Drilling is Required to Install Air Lift Suspension Kit # AL59507 in 2000 Jeep Cherokee
Published 06/07/2019
Question:
For 2000 Jeep Cherokee XJ 4WD rear instl, what drilling is required?
asked by: King
0
Expert Reply:
The Air Lift kit part # AL59507 that you referenced does require some frame drilling to install. Basically you need to first drill 5/16 inch pilot holes in the frame so that you can then drill in the included self-tapping screws.
If you check step 5 of the attached install instructions you'll see this step explained.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Air Lift Ride Control Air Helper Springs - Rear Axle
- Vehicle Suspension
- Towing/Load Leveling
- Air Springs
- Suspension Only
- Standard Duty
- Rear Axle Suspension Enhancement
- Air Lift
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Parts Needed to Install Replacement Leg for etrailer and Ram Hydraulic Jack Setup on Dump Trailer
- Q&A: Comparing the Air Lift 7500 Airbags vs Firestone 7500 Airbags for a 2015 GMC Sierra 3500
- Q&A: How To Hook Up a Blackstone Tailgater To a Quick Disconnect Propane Port On Trailer