Is 2.0 the Highest Setting for the Draw-Tite Activator Brake Controller

Updated 05/28/2019 | Published 05/24/2019

Question:

My break control only goes up to 2.0 starting at .5 is that correct. I have a activator brake controller. I tested the water in the back of the truck in the light was very dim got brighter as it went to two but the controller only goes to two. Thanks

asked by: Kevin K

Expert Reply:

Yes, the 2.0 setting that you mentioned on the Activator II is the highest setting when you are only using the control up or down. You can adjust it to a higher 4o settings by sliding the Sync Control ahead while holding the brake pedal.

I have attached some cutouts from the instructions for the Activator II that you can check out.

expert reply by: Jon G