How Far Apart Are the Mounting Holes on the Gustafson RV LED Pendant Light
Updated 04/30/2019 | Published 04/27/2019 >
Question:
Are all the mounting holes the same width im replacing old lights.
asked by: George W
0
Expert Reply:
The two mounting holes on the Gustafson RV LED Pendant Light part # 277-000461 are around 2-3/4" apart on center. I went out to our warehouse to confirm this for you. If these are what the mounting holes on your trailer measure to be then this will be an exact replacement for you. However, if they are not then you can just drill new holes as the base will cover the old ones anyhow.
expert reply by:
Conner L
0
Product Page this Question was Asked From
Gustafson 12V RV LED Pendant Light w/ Light Shade - 19" Tall - Satin Nickel
- RV Interior Lights
- Pendant Light
- Warm White
- No Switch
- Surface Mount
- LED Light
- Nickel
- Gustafson Lighting
more information >
Continue Researching
- Q&A: Cutting Extension Rod of Gustafson RV LED Pendant Light
- Q&A: Why Does My GMC Sierra Show Check Trailer Lamp Warning with LED Lights on My 5th Wheel?
- Q&A: Recommended Magnadyn Linear Series RV Stereo Replacement
- Q&A: Do You Still Carry the Gustafson Pendant Light 277-000421? What Could be a Replacement?
- Q&A: Troubleshooting Air Lift WirelessOne Compressor System Cycling On and Off Constantly
- Q&A: Correct Replacement for TDE 46210 Trailer Hub
- Q&A: RV Pendant Light Shade Replacement Recommendation
- Article: RV Lighting Interior Design Collections
- Article: 5 Reasons to Convert Your RV Lights to LEDs Today
- Article: Ugly RV Makeover: How to Change Outdated RV Lighting

