Does Bump Stop of 2008 Dodge Durango Need to be Removed to Install Air Lift Suspension Kit
Updated 04/30/2019 | Published 04/11/2019 >
Question:
I purchased he air lift 60808 for my 2008 Durango. I need to know if the bump stops that are in the coil springs need to be removed for installation, and if so how it is done. also the instructions are pretty simplistic and do not indicate weather the air bag needs to be installed with the air fitting facing up towards the vehicle or down towards the ground. any help would be greatly appreciated
asked by: NICK S
Expert Reply:
The bump stop in your 2008 Dodge Durango is mounted external of the coil spring. It will not need to be touched to install the Air Lift kit part # AL60808. The barbed air port is to be routed up though the top of the coil spring. So pointing up.
Product Page this Question was Asked From
Air Lift 1000 Air Helper Springs for Coil Springs - Rear
- Vehicle Suspension
- Towing/Load Leveling
- Air Springs
- Suspension Only
- Light Duty
- Rear Axle Suspension Enhancement
- Air Lift
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Where is the Brake Controller Adapter Plug on a 2006 Dodge Durango
- Q&A: Replacement Hub for Older Dexter 8-245
- Q&A: Is Wiring Kit Active or Passive For Stealth Hitches Receiver & Towing Kit For 2018 Audi S4
- Q&A: Parts Needed and Wiring Methods for Adding 110 and 12 Volt Power and Accessories to a Trailer
- Q&A: Are Bearings L44549 and L44649 Interchangeable

