SumoSprings Solo Custom Helper Spring Kit SSR-114-54 for 2008 F-250 4WD
Updated 04/10/2019 | Published 04/08/2019
Question:
Which part will work for my truck? Also, I am a woman with basic knowledge of working on my truck. Can I handle this?
asked by: Jerri M
Expert Reply:
You can totally handle the install of the SumoSprings Solo Custom Helper Spring Kit # SSR-114-54 in your 2008 F-250 4WD that has the B&W gooseneck hitch installed. The USA-made # SSR-114-54 is a bolt-on kit that needs no drilling.
You'll simply remove the worn factory bump stops and the replace them with the Sumos. These will give you progressive resistance as the load on them increases. At half compression they support 2800-lbs but they can compress as much as 80% when you need them to. Please have a look at the linked video to see how they bolt on.
Product Page this Question was Asked From
SumoSprings Solo Custom Helper Springs - Rear Axle
- Vehicle Suspension
- Towing/Load Leveling
- Bump Stops
- Suspension Only
- Standard Duty
- Rear Axle Suspension Enhancement
- SuperSprings Intl
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Best Air Bag Suspension 2025
- Q&A: Can You Use Longer Shackle Straps To Raise Ride Height Of Trailer?
- Q&A: How Does the Timbren Rear Suspension Enhancement System Install On a 2015 Ford F-250
- Q&A: Is it Normal for Timbren To Not be Centered Over Axle Mount
- Q&A: Difference Between Line Pull and Gross Trailer Capacity for Curt Front Hitch 31038
- Q&A: What Replacement Bump Stops Are Confirmed to Fit a 2024 Ford F-350 Super Duty?
- Q&A: Will Timbren Springs Fit On 2013 Ford F-250 Without The Raised Bump Stop Above The Axle Tube?
- Q&A: Will the Air Lift LoadLifter 5000 Air Helper Springs # AL57395 Fit a 2016 Ford F-350 Super Duty DRW
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)