Does Rear View Safety Backup Sensors part # RVS-115 Require Bumper Drilling
Updated 04/01/2019 | Published 03/29/2019
Question:
I HAVE A 2018 f150 WITH FACTORY BACKUP CAMERA, BUT NO BUMPER SENSORS. does this kit require drilling the bumper? How does it get tied to the vehicle system, if at all thanks as usual
asked by: James H
0
Expert Reply:
You will need to drill 4 holes in the rear bumper of your 2018 Ford F-150 to install the Rear View Safety Backup Sensors part # RVS-115. You'll want to drill them at equal distances in the rear bumper. The holes will need to be 21.5 mm when not using the grommets or 25 mm when using the grommets.
This does not tie into the wiring of your vehicle aside from power and ground.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Rear View Safety Backup Sensor System
- Backup Camera
- Sensor and Alert Systems
- Rear Mount
- Hardwired
- Audio Alerts Only
- Backing Up
- Obstacle Alerts
- Rear View Safety
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Installation Time for Blue Ox BX1128 Flat Tow Base Plate Kit for 2016 Jeep Grand Cherokee
- Q&A: What MCD Innovations Shade Motor do I Need to Replace My Motor with mcd.sc.28-12v.1?
- Q&A: Comparing Blue Ox Sway Pro # BXW1000 to # BXW1006
- Q&A: Does the Blue Ox SwayPro Weight Distribution System Count as Tongue Weight
- Q&A: Installed The Hopkins 41144 Wiring Harness On My 22' Colorado, 7 Way Plug Is Not Working, Any Ideas?
- Article: 5 Things to Know About Weight Distribution Hitches
- Q&A: Installation Instructions for Reese Dual Cam Weight Distribution System
- Q&A: Comparing Weight Distribution Systems that Use Chains Versus No Chains
- Article: Brake Controller Installation on a Full-Size Ford Truck or SUV
- Article: How to Measure for Trailer Hitch Drop
- Article: Gooseneck to 5th Wheel Adapters