Bolt-on Hanger Spacing for Slipper Spring # SP-178275
Updated 03/15/2019 | Published 03/14/2019
Question:
Im rebuilding my old boat trailer with SP-178275 slipper springs and the bolt-on hangers CE14016G and CE14017G. Should the center-to-center distance between the front and rear hangers for these springs be 22.75 inches? The B dimension in the length table. Thanks.
asked by: Tom
1
Helpful Expert Reply:
Yes, the B measurement of the slipper spring part # SP-178275 that you referenced is the correct hanger spacing to use. This puts the spring right where it needs to be on the rear hanger.
expert reply by:
Jameson C
1
Product Page this Question was Asked From
3-Leaf Slipper Spring w/ Radius End for 1,500-lb Trailer Axles - 24-5/8" Long
- Trailer Leaf Springs
- Slipper Springs
- 9/16 Inch Eye
- Nylon Bushings
- 1500 lbs
- 1-3/4 Inch Wide
- 3 Leaf
- 24-5/8 Inch Long
- Standard Grade
- Universal Group
more information >
Continue Researching
- Q&A: Square Trailer U-Bolt with 1-3/4
- Q&A: Replacement Axle And Leaf Springs For A 4' x 6' Single Axle Trailer
- Q&A: Do You Have a 2" Wide 4 Leaf Spring for a 2,990lbs Axle on My Trailerman Single Axle Trailer?
- Article: Slipper Spring Trailer Suspension System Review
- Q&A: Replacement Slipper Leaf Spring for Triton PWC Trailer
- Q&A: Where to Install the Malone Storage Box on MicroSport Trailer
- Article: Where to Position the Trailer Axle?
- Q&A: How to Determine if 4-Lug Trailer Hubs can be Changed to 5-Lug Trailer Hubs
- Q&A: How To Properly Measure Slipper Springs For Your Trailer's Leaf Sping Suspension
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Double-Eye Trailer Suspension System Review
- Article: How to Replace Trailer Leaf Springs in 5 Steps
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: How to Tell the Weight Rating of a Trailer Axle