Bolt Hole Measurements on Flexco Pull
Updated 09/17/2018 | Published 09/16/2018
Question:
What is the distance between the side bolt holes from front to back? Will this fit Forrest river ks27 popup high wall trailer 2015?
asked by: Jeffrey
0
Expert Reply:
The Flexco steps, part # SMFP-2120, have six holes on each side. The top set is 4-1/2 inches center on center and both the lower sets are 9-1/2 inches.
Additionally the top holes measure 7 inches center on center between the bolt holes front to back and are 20-1/2 inches across.
expert reply by:
Charles S
0
click to enlarge
Product Page this Question was Asked From
Flexco Manual Pull-Out Steps for RVs - Double - 8" Drop/Rise - 20" Wide - 300 lbs
- RV Steps
- Towable Camper
- Pull-Out Step
- 20 Inch Wide Step
- 23-5/8 Inch Wide
- 2 Steps
- 8 Inch Drop/Rise
- 19 Inch Entry
- 20 Inch Entry
- 21 Inch Entry
- 22 Inch Entry
- Steel
- Stromberg Carlson
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Will Pull Out Steps fit 2011 Palomino Puma 27KFQ
- Q&A: Mounting Hole Spacing on the Flexco Manual Pull-out Steps for RVs
- Q&A: Replacement A-Frame Jack for Lippert Ground Control TT
- Q&A: Flexco Double Step Width Dimensions
- Q&A: Double Step Replacement for 2017 R-Pod 180
- Q&A: Parts Needed To Install a 12 Volt Battery To an Off Road Trailer For Lighting
- Q&A: Can 2-Step Lippert Steps Replace a Single Step on a 2017 Winnie 170S
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: 4-Step Guide to Installing RV Solar Power
- Article: Calculating Portable Generator Power Needs
- Article: Is It Illegal to Leave My Hitch on My Truck?
- Article: Trailer Wiring Diagrams
- Article: How Does an RV Water Pump Work?