Tips on Driving a Roll Pin In or Out to Replace Ladder Rung 8538-T
Published 09/14/2018
Question:
how does one remove the existing roll pin in order to put the replacement rung in the ladder? Are special tools needed?
asked by: Mark
0
Expert Reply:
If you have a center punch or a very thin screwdriver you could drive out the roll pins, or drive them in, using a hammer. You don't have to have any special tools unless you do not have anything that is no larger than the diameter of the roll pin.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Replacement Rung for Stromberg Carlson RV Exterior and Bunk Ladders - Qty 1
- Accessories and Parts
- RV Ladders
- Rung
- Stromberg Carlson
more information >
Continue Researching
- Q&A: What is Length of Stromberg Carlson Stand Off SCS44SR
- Q&A: Dimensions Of Replacement Rung for Stromberg Carlson RV Exterior Ladder
- Q&A: What Does Roll Pin Look Like on Replacement Ladder Rung
- Q&A: Recommended Replacement to Replace Kimberly Ladder End Caps
- Q&A: Replacement Tail Lights for 2016 Forest River FR3 Class A
- Q&A: Replacement 14 x 7 Triple Tail Light Recommendation for RV
- Q&A: Availability of Ladders and Ladder Parts for Keystone Cougar 5th Wheel Trailer