Dimensions of the Optronics Halogen Docking Light Kit
Published 10/13/2011 >
Question:
Do you have dimensions for the light? Can mount be attached to a vertical surface and still tilt light beam to be essentially horizontal? Or is a horizontal mounting surace required? Thanks
asked by: Robert L
Expert Reply:
I went out into our warehouse and pulled a Halogen Docking Light Kit # DL-16CC to measure and see if it could be mounted on a vertical surface and found that the dimensions are:
5-3/4 inches in width
2-7/8 inches in height
2 inches in depth
The mounting bracket of the lights pivots nearly 180 degrees and would allow you basically mount this on nearly any vertical or horizontal surfaces. Check out the video I put together for you that shows the measurements and the range of the pivoting mounting bracket.
Product Page this Question was Asked From
Halogen Docking Light Kit - 35 Watt - Lighted Switch and Safety-Fused Wiring - Black Housing
- Boat Lights
- Docking Lights
- Deck
- Black Housing
- Surface Mount
- Halogen Light
- White
- Optronics
more information >
Continue Researching
- Q&A: Will The Curt Trailer Hitch Receiver C82RJ Fit The 2027 Kia Telluride
- Q&A: Why Does a Marker or Clearance Light Only Have One Wire
- Q&A: Which Pin On A 7-Way Should Have Constant 12V Power When Vehicle Is Running
- Q&A: Replacement LED Flood Light for Load Lights on a Horse Trailer
- Article: Roadmaster Vehicle Specific Base Plates
- Q&A: Is There a Support Brace Designed for the Replacement Crank Extension for Lippert Spare Tire Winch?
- Q&A: Recommended 4" x 6" Utility Work Light
- Q&A: Does the Macerating Seaflo Fresh Water Electric RV Toilet Fit a Standard Toilet Flange?
- Article: Aftermarket Brake Control Wiring for 07-13 GM Full-Size Truck with Factory-Integrated Brake Control
- Article: Trailer Lighting Requirements

