Where to Find Stoplight Circuit on 2014 GMC Terrain to Install Brake Controller
Updated 09/04/2018 | Published 09/03/2018
Products Featured in This Question
Question:
Where do I find the location to connect the red wire from the Tekonsha 90195 P3 to a 2014 GMC Terrain?
asked by: Steve D
0
Expert Reply:
The stop light switch circuit on your 2014 GMC Terrain that you will need to find to install the Prodigy P3 part # 90195 will need to be accessed through the body control module (BCM). The BCM is located under the driver's dash above where your left knee would be.
If you check out the picture I attached you'll see exactly where to find it.
expert reply by:
Jameson C
0
click to enlarge
Product Page this Question was Asked From
Draw-Tite Activator IV Trailer Brake Controller - Up to 4 Axles - Time Delayed
- Trailer Brake Controller
- Time Delayed Controller
- Electric
- Plug-In
- Under-Dash Box
- Under-Dash
- Up to 4 Axles
- LED Display
- Single Trailer Only
- Draw-Tite
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Recommended Trailer Hitch and Wiring Harness for a 2025 Kia Sorrento Hybrid
- Q&A: Will Kodiak Trailer Hub for 3,500-lb Axles Fit Dexter 80043A Spindle On Boat Trailer
- Q&A: Help Picking Out Replacement Axle for 2004 Ranger Trail Trailer
- Q&A: Replacement Hub and Drum Assemblies for AL/KO 8460 Hubs and Drums
- Q&A: Replacing Wheels on a Trailer with 5 Spoke Utility Hubs and 8-14.5 Size Tires
- Q&A: Can 2020 Kia Soul-GT Turbo DCT be Flat Towed behind Motorhome
- Q&A: Difference Between Tekonsha 119251 and 119250 ZCI Wiring Harness for Mini Cooper
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Troubleshooting Brake Controller Installations
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Double-Eye Trailer Suspension System Review
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: Trailer Wiring Diagrams