Can CURT Font Mount Trailer Hitch C31013 Be Mounted on a 2001 Toyota Tacoma with a Grille Guard
Updated 10/11/2011 | Published 10/10/2011
Question:
Can a front hitch be mounted with a full grille guard on a 2001 Toyota Tacoma? I know I have seen this done on other trucks but after reading the installation instructions for both I am beginning to question whether it is possible on mine.
asked by: Chad
Expert Reply:
You have done the right thing by reading the installation instructions. Since CURT Front Mount Receiver, # C31013, was not tested on vehicles with any type of grille guard, the only way to determine fit is to look at the instructions for both parts.
In the CURT instructions which I have linked for reference, you will see that at the front frame rails of your 2001 Toyota Tacoma there should be 3 holes. The front most hole is just a hole that will be enlarged to install the hitch. The 2 holes behind that have weldnuts inside. If the grille guard you have mounts in the same place of needs that area of the frame for any reason, the hitch cannot be mounted.
Product Page this Question was Asked From
Curt Front Mount Trailer Hitch Receiver - Custom Fit - 2"
- Front Receiver Hitch
- Visible Cross Tube
- 500 lbs Vert Load
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Hitch and Wiring for 2023 Nissan Frontier Without Tow Package
- Q&A: 2004 Toyota Tacoma Trailer Hitch Receiver Recommendation
- Q&A: Replacement Propane Gas Detector for an Atwood 31013 Propane Detector
- Q&A: Upgrading WFCO Panel And Charger To Lithium In 2021 Grand Design Reflection 150
- Q&A: What Are the Dimensions of the Westin Fey Diamondstep Rear Bumper 20009
- Q&A: Is GE RV Air Distribution Box GE49FR Compatible with GEDeluxe Plus RV AC GE64FR ?
- Q&A: Recommended Replacement for Greystone Range Hood G22BRH-TK
- Article: Redarc Tow-Pro Elite Full Review