How Much Shaft is Used When Installing Roller with Palnuts
Updated 07/30/2018 | Published 07/29/2018
Products Featured in This Question
Question:
1. How deep is the cap nut? In other words how much rod will be covered up by the cap nut? 2. What’s the best way to put the cap nut on the rod? Is the fit such that the cap nuts need to be lightly hammered onto the rod?
asked by: Kurt C
0
Expert Reply:
To give you an idea how much length of a shaft the # CE10801 takes up the part # CE10401G is a roller assembly that holds a 5 inch long roller and the shaft length is overall 6-1/4 inches. So that means you pick out the shaft length by adding 1-1/4 inches to the length of the roller you are using. This setup uses the same palnuts.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Replacement Cap Nut - Zinc - 5/8" - Qty. 1
- Accessories and Parts
- Boat Trailer Parts
- Hardware
- 5/8 Inch Diameter
- Nuts
- Cap Nut
- CE Smith
more information >
Continue Researching
- Q&A: Brake Controller Install on 1997 Chevrolet Pickup
- Q&A: Surge Brake Actuator Repair for Titan Drum Brake Actuating Coupler
- Q&A: Differences Between CE48810 and CE48870 CE Smith Multi Sport Boat/Kayak Trailer
- Q&A: How Much Additional Length Does The Extra Long Trailer Tongue for CE Smith Multi-Sport Trailers Add
- Q&A: Can 8 Inch Trailer Tires be Replaced with 12 Inch Trailer Tires
- Q&A: Can CE Smith Multi Sport Plus be Used to Haul a SCAMP Sailboat
- Q&A: How to Remove Cap Nut on Roller Shaft
- Article: Trailer Lighting Requirements
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: How to Accurately Measure Trailer Leaf Springs