Which Pins of 6-Way are for 12 Volt Power and Ground
Published 07/26/2018 >
Question:
I currently have a 4 way coiled cable from rv to towed vehicle. I just had the shop run two wires from chassis battery to back of rv. A towed battery charger is being shipped now. So I want to buy a 6 way cable and connector from you guys. My question is if the positive wire from battery goes to connector center pin, where does the negative side go? Thank you very much for your help.
asked by: John H
Helpful Expert Reply:
I attached a picture that has a diagram of how a 6-way wiring harness is pinned out. The center pin is the 12 volt power circuit and the pin in the 1:00 position on the female socket as you face the open connector is the ground circuit.
Product Page this Question was Asked From
RoadMaster 6-Wire Flexo-Coil Kit
- Flat Tow Wiring Harness
- Plugs into Vehicle Wiring
- Extension Cord
- Universal Fit
- 6 Round
- Roadmaster
more information >
Continue Researching
- Q&A: Length of Cable In Roadmaster Straight Power Cord for Tow Bars with Cable Guides # RM82BQ
- Q&A: Replacement Replacement 7-Way to 6-Way Coiled-to-Straight Cord For Roadmaster Nighthawk
- Q&A: Does Blue Ox Towed Vehicle Battery Charge Line Wiring Harness # BLU44ER Have Backfeed Protection
- Q&A: Replacement Propane Hose for Marshall HP424
- Q&A: Recommended Parts to Flat Tow a 2017 Ram 3500
- Q&A: Base Plates For 2009 Honda Fit & Roadmaster Falcon 2 Tow Bar
- Q&A: What Gauge Wires are in the Demco 7-Wire to 6-Wire Coiled Electrical Cord w/ 6-Way Round Plug?
- Article: We Used 34 RV Tow Bars, and These are the Best for Flat Towing
- Article: Tow Bar Wiring: Which Wiring Kit is for You?
- Article: Flat Towing Package for 2007-2018 JK Jeep Wrangler and Wrangler Unlimited
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)


