Distance Between Mounting Holes on a Redline Plunger and Socket Door Holder
Published 09/22/2011 >
Question:
Are there dimensions for the mounting holes available for this part? In other words, do you have a print available? Please advise.
asked by: Tom B
0
Expert Reply:
I went out into our warehouse and pulled a Plunger and Nylon Socket Door Holder # DH604 to measure it and found that the distance between the mounting holes is 1-1/4 inches.
Check out the video I attached that shows me measuring the mounting holes with a dial caliper.
The holes are 3/16 inches in diameter. Check out the picture I attached to see this measurement.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Plunger and Nylon Socket Door Holder - 1" Long Plunger
- Trailer Door Holders
- Plunger and Socket
- Straight
- 1 Inch Long
- Plastic
- Redline
more information >
Continue Researching
- Q&A: Will a Dylux AC System Replace an Older Dometic Model AC w/ 410a Refrigerant?
- Q&A: Longest Available Door Replacement Plunger
- Q&A: Replacement Plunger Door Holder Socket for a Polar 68 Socket
- Article: Trailer Wiring Diagrams
- Q&A: Can 1/2 Inch Wheel Stud With .54 Inch Knurl Fit Hub With .55 Inch Knurl Stud
- Q&A: Replacement Trailer Jack Recommendation for Shelby Jack 5854A
- Q&A: Recommended Replacement Jack for Shelby Trailer Jack
- Q&A: How to Locate the Reverse Light Wire on the Back of a 2017 Toyota Highlander
- Article: Aftermarket Brake Control Wiring for 07-13 GM Full-Size Truck with Factory-Integrated Brake Control
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Install E-Track in 3 Easy Steps
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Lighting Requirements


