What is the Thread Size for the Replacement Handle for Bladex and Valterra Waste Valves # T1003-6GN
Published 06/06/2018
Question:
Hi What is the thread size for the Valterra waste water handle that attaches to valves The shaft is threaded to accept a new handle but I want to make my own out of aluminum or stainless steel. 2009 Crossroads Zinger 30-QB fifth wheel
asked by: John
0
Expert Reply:
The Replacement Handle for Bladex and Valterra Waste Valves # T1003-6GN has 1/4" thread. My contact at Valterra confirmed this.
expert reply by:
Jon G
0
Product Page this Question was Asked From
Replacement Handle for Bladex and Valterra Waste Valves - Threaded - Plastic - Gray
- Accessories and Parts
- RV Waste Valves
- Waste Valve Parts
- Handles
- Valterra
more information >
Continue Researching
- Article: RV Pre-Departure Checklist
- Q&A: Which Slide Topper For 154 Inch End to End Slide-Out on 2020 Coachmen Apex Ultra-Lite
- Q&A: Correct Replacement for an Atwood Water Heater GC6AA-9E
- Q&A: Visual Difference Between Old and New Style of Valterra 1-1/2 inch Valve Seal
- Q&A: Do You Need Teflon Tape For A Propane Pigtail Connector.
- Q&A: Recommended Replacement for Atwood GC10A-4E RV Water Heater
- Q&A: Replacement Converter for Parallax Model 7155
- Q&A: Replacement Gray and Black Waste Valve Handles For RV Campers
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Wiring Diagrams
- Article: What To Look For When Buying Ratchet Straps
- Article: Flat Tow Package for 2011-2013 Jeep Grand Cherokee