Does Crank Handle on Swivel Jack # PS1401020303 Just Hang Down when Jack is Rotated Up
Updated 06/01/2018 | Published 05/30/2018
Question:
the handle on this jack appears to rotate freely so what happens to the handle when you swing the jack up for travel? does it stay up or fall down and if so, what keeps it up?
asked by: Jay P
Helpful Expert Reply:
With jack # PS1401020303 fully retracted the crank handle cannot be turned any further and would support itself. And it would take some force for it to turn the other way due to the fact that it is engaging gears that are then engaging the jack screw. This is shown though not mentioned in the video I have linked for you.
Product Page this Question was Asked From
Pro Series Round, Snap-Ring Swivel Jack - Weld On - Sidewind - 10" Lift - 2,000 lbs
- Trailer Jack
- Enclosed Trailer
- Utility Trailer
- Side-Mount Jacks
- Swivel Jacks
- Sidewind Jack
- 1001 - 2000 lbs
- Manual Jack
- 10 Inch Lift
- Weld-On
- With Rectangle Foot
- Pro Series
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Recommended Hydraulic Jack Leg That Can Be Used w/a Hydraulic System on a Dump Trailer
- Q&A: Tool to Drive in 2.72" Hub Dust Caps
- Q&A: Replacement Tray for Stromberg Carlson Trailer Tray Dimensions
- Q&A: Can EZ Gate Tailgate Lift Assist Fit on Trailer with Folding Tailgate
- Q&A: Can I Flat Tow a 2023 Ford Bronco Using the Recovery Hooks?
- Q&A: Replacement Inner Parts for Demco 12.5K Weld-On Actuator
- Q&A: Replacement Bearings for AL-KO Axle on 2013 Northwood Arctic Fox 29-5K