Can the T-One # 118469 be Installed Without Going Through the Hatch on a 2007 Nissan Quest
Published 05/22/2018
Products Featured in This Question
Question:
Is there a way to install the wirin g harness without running the wires out the rear hatch door when in use?
asked by: Jason H
Expert Reply:
You could route the 4-Way connector on the T-One # 118469 through the floor of the trunk on your 2007 Nissan Quest. If you use a rubber grommet like part # A55GB and some sealant like the Loctite RTV 598 # LT37467 it would create a seal so you wouldn't have to worry about having an opening in your floor.
Sometimes there is already an existing grommet in which case you would simply cut a slit in it for the 4-Way.
To keep your 4-Way secure I recommend using the Mounting Bracket # 18144 as well as the No-Drill Mount Bracket # 18140.
Attached is an installation of this kit on a Quest as well as an example of the grommet installation on a 2013 Ford Edge (mark 4:15) for you to reference.
Product Page this Question was Asked From
T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Vehicle End Connector
- Powered Converter
- No Tow Package
- 4 Flat
- Plug and Lead
- Plug-In
- Hidden
- Tekonsha
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Recommended Brake Controller And Installation Kit For 2017 Mercedes-Benz Sprinter 3500
- Q&A: How To Install a Brake Controller on 2017 Mercedes-Benz Sprinter 3500
- Q&A: Replacement Tail Light Lens for 1992 Coleman Pop-Up Camper
- Q&A: Replacement Amber Lens Needed for a 2009 Coleman Utah Pop Up Camper
- Q&A: Troubleshooting the Fuse Blowing on the Demco Stay-IN-Play Duo Braking System
- Q&A: Replacement Lens for Clearance/Side Marker Light for a 2001 Coleman Pop-Up Camper
- Q&A: Trailer Hitch Recommendation for 2020 Kia Soul