Can Wiring be Soldered to the Back of the Pollack 2-Pole Vehicle Side Trailer Connector
Updated 08/09/2011 | Published 08/08/2011
Products Featured in This Question
Question:
are cables soldered to connectors on this part?
asked by: Jeff
0
Expert Reply:
The Pollack 2-Pole Connector, # PK12801, is designed to have the wires attached with ring terminals. By crimping on ring terminals to the ends of the wires and then holding them on with the included screw, it will provide a strong and quick attachment method. The last picture on the product page shows a clear view of the back where the wires attach.
This connector is the vehicle side. If you also need the matching trailer side, it is # PK12800.
expert reply by:
Michael H
0
Product Page this Question was Asked From
2-Pole Socket Connector - Vehicle Side
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Vehicle End Connector
- 2 Pole
- Plug Only
- Pollak
more information >
Continue Researching
- Q&A: Winch Battery Recommendation for 3000-lb Winch with 170 Amp Draw
- Q&A: Electric Boat Trailer Winch With Remote Capable Of Pulling 3,000-lbs
- Q&A: Methods for Powering Electric Winches
- Q&A: Recommended Electric Winch With Remote for Boat Trailer With 8,000 Pound Grady White Gulfstream
- Q&A: Do 7-Way Trailer Connectors have Amp Ratings for Pins or the Whole Socket
- Q&A: Could Redarc Tow Pro Link be Used to Tow Second Trailer
- Q&A: Instructions to Wire a Trailer for Electric Brakes
- Article: How to Measure for Motorhome Steps
- Article: Roadmaster Vehicle Specific Base Plates
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Lighting Requirements
- Article: How to Wire an Electric Winch
- Article: Determining Trailer Tongue Weight
- Article: Most Popular Wheel Bearings