Will the CIPA Top Mounted Blind Spot Mirror # CM49805 Fit a 2010 Ford Expedition
Updated 04/10/2018 | Published 04/09/2018
Question:
Will it fit my 2010 Expedition??
asked by: Michael R
Expert Reply:
The CIPA Top Mounted Blind Spot Mirror # CM49805 that you referenced is a universal clamp on fit. We haven't test fit it on a 2010 Ford Expedition, but I have no reason to doubt why it would fit.
I went out to the warehouse and took some quick measurements to help you know if it will properly fit your mirror. The plate that slides between your mirror housing and the mirror itself is 1/16" thick. The smallest that the opening between the screws and the plate is 1/8". You can use these measurements along with the attached photo and review video to help you determine a fit.
Product Page this Question was Asked From
CIPA Top Mounted Blind Spot Mirror - Convex - Clamp On - 4" Oval - Qty 1
- Blind Spot Mirror
- Convex
- Clamp-On
- Oval
- 4W x 1-1/4T Inch
- CIPA
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Air Bags for 2022 Nissan Frontier Extended Cab
- Q&A: Low Profile Trailer Jack Recommendation for Better Tailgate Clearance
- Q&A: Trailer Wiring Fault on 2015 Ford F-150 with Factory Trailer Brake Controller
- Article: Which Sway Control Hitch is Right For Your Trailer?
- Q&A: How to Charge Battery for Fridge Using Alternator and Solar Power
- Q&A: What Gauge Wire Is Required On a 7-Way Connector
- Article: How to Choose the Right Trailer Hitch Class
- Article: How to Measure for Trailer Hitch Drop
- Article: The Best Towing Mirrors
- Q&A: Choosing Between the CIPA and K-Source Universal Towing Mirrors for a 2008 Ford Expedition
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Q&A: Trailer Hitch and Ground Clearance for a 2006 Toyota Matrix XRS and Curt Trailer Hitch # C12013
- Article: Converting Your RV Water Heater to Tankless
- Article: The Best Trailer Tongue Locks for Preventing Trailer Theft