Adapter For 5-Flat Towing Plug to 4-Flat Trailer Light Plug
Question:
Does an adapter for a 5-flat vehicle side to 4-flat trailer side, without rewiring the light harness on the vehicle, exist? If so where can I find it?
asked by: Roy
0
Expert Reply:
If you were wondering if you need to make the trailer a 5-way, technically a 4-way and 5-way can plug into each other, so you don't have to do anything. You don't even have to wire the vehicle side. But if you want the function of the 5th pin, then you will need to add a 5-way to the trailer and wire it with # HM47910.
expert reply by:
Timothy G
0
Product Page this Question was Asked From
Hopkins Endurance 5-Way Flat Trailer Connector - Trailer End - Ergonomic Design
- Trailer Wiring
- Trailer Connectors
- Trailer End Connector
- 0 - 5 Feet Long
- Plug and Lead
- 5 Flat
- Hopkins
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 5-Way Plug (It's Easier Than You Think)
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Parts Needed to Add Hydraulic Disc Brakes to a Trailer
- Q&A: Adapting a 7-Way to a 4-Way On a 2012 Honda Pilot for Thule Arcos Enclosed Cargo Carrier # TH25YE
- Q&A: How to Lock Out a Model 10 Actuator When Going to an Electric Over Hydraulic Setup
- Q&A: Can I Convert My Titan Surge Brake Actuator To Have A Reverse Lockout?
- Q&A: Comparing the Brake Buddy Classic 3 and Brake Buddy Select 3 Supplemental Brake Systems
- Q&A: Parts Needed to Add 5-Way to 2023 Toyota Tacoma
- Q&A: Diameter of 3,500 lb Dexter Trailer Axle 35545I-ST-89
- Q&A: Solera 63 inch Arm Replacement
- Article: Best Boat Trailer Jacks
- Article: How to Bleed Your Trailer Surge Brakes