Should I Get the Hydroflush with a 45 or 90 Degree Bend
Published 02/15/2018
Products Featured in This Question
Question:
Do you recommend the 45 or 90 degree bend Hydroflush?
asked by: Homer
0
Expert Reply:
The 45 degree, part # F02-4100, and the 90 degree, part # F02-4110, Hydroflush Reverse Flush Adapters are the same product other than the bend in the line. Which is beter for you depends on your specific application.
Most people seem to prefer the 45 degree angle works better for them because of where the waste valve is located on their RV. For some the waste valve is very low and close to the ground so the 90 degree makes it easier.
expert reply by:
Charles S
0
Product Page this Question was Asked From
Valterra Hydroflush Reverse Flush Adapter for RV Holding Tanks and Sewer Hoses - 45-Degree
- RV Waste Valves
- Flush Valves
- 3 Inch Bayonet
- Stationary Valve
- Valterra
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Replacement Roof Vent Lid for Dexter Roof Vent Serial Number VE0108
- Q&A: Recommended LCD Single Zone Thermostat for Dometic RV Air Conditioners
- Q&A: Is There a Replacement for a Trimark 030-0900 Door Latch
- Q&A: 2000 Fleetwood Mallard Hot Water Heater Location Atwood GC6AA-8
- Q&A: What is Difference Between 912 and 921 Bulbs
- Q&A: Need Replacement For Atwood Propane Detector Model LP-DRW 36720
- Q&A: Replacement Taillight Lens Recommendation for 2010 Rockwood Premier A122
- Article: Is It Illegal to Leave My Hitch on My Truck?
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: The Ultimate RV Camping Checklist for Your First Year RVing
- Article: Camping Tips for First-Time RVers
- Article: Cleaning Your RV Black Water Tank in 4 Easy Steps
- Article: Can You Flat Tow a Ford Ranger?