How Does Pollak Solenoid Switch 52-312-01 Wire
Published 02/13/2018
Question:
How do I wire in this switch, which wires go where?
asked by: Dan
0
Expert Reply:
Basically the Pollak wires in line with where power needs to be transferred. So if you were using this as a starter solenoid the power wire that runs to the starter would have this ran inline on the bigger terminals and then the smaller terminal is the circuit that activates the solenoid and allows the power to transfer to the starter.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Starter Solenoid - SPST - 12 Volt - 100 Amp - Continuous Duty - Grounded
- Accessories and Parts
- Battery
- Switches and Solenoids
- 100 Amp
- Pollak
more information >
Continue Researching
- Video: Detailed Breakdown of the Starter Solenoid
- Search Results: pollak wiring
- Q&A: Diagram for Wiring In Isolation Solenoid part # PK5231201
- Shop: RV Propane Gas Detector - 12 Volt - 2 Wire - Black
- Shop: Starter Solenoid - SPST - 12 Volt - 100 Amp - Continuous Duty - Grounded
- Q&A: How to Turn Off 12-V Power Feed to 7-Way Trailer Connector on Vehicle When Ignition is Shut Off
- Q&A: My Owners Manual is Saying to Not Install a Hitch, but You Have One Listed to Work, What Should I do
- Q&A: How to Find Replacement for 4 Lug Hubs on Utility Trailer
- Q&A: Troubleshooting A Brake Buddy Stealth Braking System That Activates When Not Flat Towing
- Q&A: Replacement Steps for Lippert 171317
- Q&A: How to Install Brake Controller Wiring on a 2008 Toyota Tundra SR5 Crewmax
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Brake Controller Installation on a Full-Size Ford Truck or SUV
- Article: How to Charge a Trailer Battery While Driving: 3 Common Problems (And How to Fix Them)
- Article: How to Troubleshoot Your RV Air Conditioner
- Article: How Many Batteries Do You Need to Run an RV Air Conditioner?