Sealing Up Gaps between Trailer Lights and Trailer Body
Updated 02/12/2018 | Published 02/10/2018
Products Featured in This Question
Question:
I am replacing all the lights on a vintage camper Im restoring. I got 7 ea of the red and amber clearance lights, but they dont have any gasketing material to seal the fixture against moisture entering the camper. Is there something I can get to remedy this?
asked by: Brian F
0
Product Page this Question was Asked From
Optronics LED Clearance or Side Marker Light w/ Reflex Reflector - 6 Diodes - Oval - Amber Lens
- Trailer Lights
- Clearance Lights
- Marker
- Oval
- Surface Mount
- Non-Submersible Lights
- LED Light
- 4L x 2-1/16W Inch
- Amber
- Optronics
more information >
Continue Researching
- Q&A: Anti-Rattle Recommendation for the B&W Tow and Stow Ball Mount
- Q&A: Identifying Capacity and Replacement Parts for UFP Axle
- Q&A: How Do I Tell if I Have a Factory Tow Package on My 2022 Kia Sorento?
- Article: Trailer Lighting Requirements
- Q&A: 2016 Forest River Ford E350 Brake Controller Port Location
- Q&A: What Difference Between Dexter 7k and 8k Axle
- Q&A: How to Determine if Trailer Axle is Not Aligned and How to Measure to Replace Trailer Axle
- Q&A: Bearings and Seal Used for AL-KO 7290 Trailer Hubs for #99 Spindles
- Article: 2005-Current Volkswagen Touareg, Audi, or Porsche Cayenne
- Article: Holiday 2025 | Staff Picks for Real-Life Adventures
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Slipper Spring Trailer Suspension System Review
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)