How Does the White Socket of the Plunger and Socket # DH604 Attach to Trailer
Updated 12/04/2017 | Published 12/03/2017 >
Question:
How does the nylon socket attach?
asked by: Mary
0
Expert Reply:
The white socket of the Plunger and Socket Door Holder part # DH604 that you referenced attaches with a bolt that runs through the center of it.
I attached a picture that shows the hole down the center.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Plunger and Nylon Socket Door Holder - 1" Long Plunger
- Trailer Door Holders
- Plunger and Socket
- Straight
- 1 Inch Long
- Plastic
- Redline
more information >
Continue Researching
- Q&A: Will a Dylux AC System Replace an Older Dometic Model AC w/ 410a Refrigerant?
- Q&A: Longest Available Door Replacement Plunger
- Q&A: Replacement Plunger Door Holder Socket for a Polar 68 Socket
- Article: Trailer Wiring Diagrams
- Q&A: Can 1/2 Inch Wheel Stud With .54 Inch Knurl Fit Hub With .55 Inch Knurl Stud
- Q&A: Recommended Replacement Jack for Shelby Trailer Jack
- Q&A: Replacement Trailer Jack Recommendation for Shelby Jack 5854A
- Q&A: How to Locate the Reverse Light Wire on the Back of a 2017 Toyota Highlander
- Article: Aftermarket Brake Control Wiring for 07-13 GM Full-Size Truck with Factory-Integrated Brake Control
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Install E-Track in 3 Easy Steps
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Lighting Requirements


