Is Drilling Required to Install Carr Custom-Fit Side Steps on 2017 Toyota Tundra
Published 11/08/2017
Question:
Will these steps install on a 2017 tundra without drilling?
asked by: Christian R
Expert Reply:
The Carr Custom-Fit Side Steps # CARR104501 referenced in your question, which are confirmed to fit your 2017 Toyota Tundra, will require some drilling during installation. To attach the steps to the truck, you will need to drill holes into the back side of the rocker panel under the driver and passenger side door.
These are very nice, sturdy steps that feature a flat, non-slip surface to provide sure footing. They have a durable, cast aluminum alloy construction that will do a great job of preventing rust and corrosion. The step platforms measure 7 inches long and 3-1/2 inches wide.
I have attached the complete written installation instructions that you can also check out.
Product Page this Question was Asked From
Carr Custom-Fit Side Steps - Hoop II - Black Powder Coated Aluminum - 7" Step - 1 Pair
- Nerf Bars - Running Boards
- Side Steps
- 3-1/2 Inch Wide
- Matte Finish
- Fixed Step
- Aluminum
- Black
- Carr
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: How to Install a 6-Way Trailer Connector To Front of Flat Towed Vehicle
- Q&A: How to Wire Up Brake Controller in 2015 Chevy Colorado
- Q&A: Trailer Wiring for 2018 Lexus RX 350L Without Factory Tow Package
- Q&A: T-Bolt for Thule Roof Mounted Top Rack System
- Q&A: Thule Aero Crossbar T-slot Dimensions
- Q&A: T-bolt and Wing Knob Fit With Thule AeroBlade Channel
- Q&A: Running Boards and Rear Hitch Step for 2015 Mercedes Sprinter
- Article: Our Team Picked The Best Camping Gear of the Year - Here Are Their Top Choices
- Article: Happy Holidays from etrailer!
- Article: Performance Chips and Modules