Recommended Trailer Hitch Receiver and Wiring for 2014 Audi Allroad
Published 11/02/2017 >
Products Featured in This Question
Question:
That hitch looks great except that it hangs kind of low which will impede on ground clearance. Do you have anything that fits in a lower profile? My question is the wiring as well. I’ve heard many nightmares about how the car reacts with towing in that the rear and side sensors and back up sensors all get out of whack when installing towing wiring harness. How will my car act when hooking up a trailer wiring? Will the transmission shift differently? As you know I’m new here and am learning ( Thanks again!
asked by: Robert B
Expert Reply:
For your 2014 Audi Allroad B8.5, I recommend the Curt Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4" # C11195 which is a confirmed fit. Then you will need a ball mount like # C45521 and Pin and Clip # F-4.
Then you'll need a hitch ball. I recommend # A-82 for a 2 inch ball or # A-80 for a 1-7/8 inch diameter hitch ball to match your trailer coupler.
For your wiring, I recommend the Curt Powered Tail Light Converter with 4-Pole Flat Trailer Connector # C59236. This will allow you to connect to your factory wiring using quick splice connectors and will protect your system by using a converter that is powered directly by your vehicle battery. I've attached an article to assist.
You will not need an electric brake controller or suspension enhancement for the size trailer and load capacity of your vehicle. A new air filter will help some, but is not required to tow.
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"
- Trailer Hitch
- For Towing
- Class I
- 200 lbs TW
- 2000 lbs GTW
- 1-1/4 Inch Hitch
- Visible Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media





Continue Researching
- Q&A: Can I Use a Firestone Air Compressor w/ a Set of Pacbrake Air Bags?
- Q&A: Recommended Hitch for 2011 Audi A4 Avant Quattro Wagon
- Q&A: What Vehicles Does The Curt Hitch 13437 Fit?
- Q&A: Will the Westin R5 Nerf Bars Fit with Factory Mud Flaps on a 2021 Toyota Tacoma?
- Q&A: Can Replacement Lock Cylinder BL7023480 Work with 2015 Chevy
- Q&A: Parts Needed To Install Thule Roof Rack On Leer Camper Shell With Tracks
- Q&A: What Feet Do I Need to Install Crossbars on My Leer Camper with Thule Tracks?
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)


Robert B.
11/2/2017
That hitch looks great except that it hangs kind of low which will impede on ground clearance. Do you have anything that fits in a lower profile? My question is the wiring as well. I’ve heard many nightmares about how the car reacts with towing in that the rear and side sensors and back up sensors all get out of whack when installing towing wiring harness. How will my car act when hooking up a trailer wiring? Will the transmission shift differently? As you know I’m new here and am learning ( Thanks again!